Motocross The Game Steering Settings: Best Gain, Sensitivity and Dead Zone
Dial in Motocross The Game steering settings with tested gain, sensitivity, linearity and dead zone values, plus controller bindings and braking tips.
Your bike feels twitchy in one corner and lazy in the next, and you can't tell whether the problem is you or the game. Nine times out of ten, the culprit is your Motocross The Game steering settings. This guide walks through a proven setup from a player with about 70 hours in early access, then shows you how to tune it to your own hands.
The game officially launched on November 16, and updates will keep shifting the details. Treat the numbers below as a strong starting point, not gospel.
Why Steering Settings Matter So Much in Motocross The Game
Motocross The Game rewards smooth inputs. According to player experience from a top-ranked 250 leaderboard rider, aggressive, jerky stick movements make it easy to lose the bike, especially when you're trying to carry momentum through a rut or berm. A twitchy setup punishes every small thumb movement. A sluggish one leaves you wide in corners and scrambling to recover.
Your steering menu has four main values:
- Steering gain: how strongly the bike responds overall
- Sensitivity: how quickly stick movement translates into steering
- Linearity: how the response curve builds as you push the stick further
- Dead zone: how much stick movement is ignored near the center
Small changes to any of these add up fast. That's why the best advice is to change one value at a time and ride a few laps before judging it.
The Baseline Steering Settings (After 70 Hours)
Here is the controller steering setup that one leaderboard rider settled on after extensive experimenting. This player reports top-five and top-10 times on the 250 leaderboards with it.
| Setting | Value | What it does |
|---|---|---|
| Steering gain | +1 | Slightly boosts overall turn response |
| Sensitivity | -4 | Softens stick response for smoother inputs |
| Linearity | 0 | Neutral response curve |
| Dead zone | 5 | Ignores tiny stick drift near center |
The logic is simple. Gain at +1 gives enough bite to turn the bike without feeling nervous. Sensitivity at -4 tames the response so small corrections stay small. Linearity stays neutral, and a modest dead zone filters out minor stick noise.
What Happens When You Go Too High or Too Low
The same rider tested gain at around +3, +4 and even +5, and found the bike far too sensitive. Dropping to 0 or -1 made it hard to get the bike to turn at all. That gives you a useful range to test within.
| Gain Value | Reported Feel | Best For |
|---|---|---|
| -1 to 0 | Bike barely turns | Rarely recommended |
| +1 | Balanced, smooth | Most riders, a great start |
| +2 | Slightly sharper (untested by source) | Riders who want more bite |
| +3 to +5 | Too twitchy | Very experienced stick control only |
How to Tune Your Steering Step by Step
Copying numbers is a fine starting point, but your controller, thumbs and riding style matter. Use this process to find your own settings without going in circles.
| Step | Action | What to watch for |
|---|---|---|
| 1 | Enter the baseline values above | Note how the bike feels in the first corner |
| 2 | Ride 5 to 10 laps on one track | Look for consistency, not one fast lap |
| 3 | Change only sensitivity by one step | Try -3 or -2 if turns feel lazy |
| 4 | Ride another 5 to 10 laps | Compare how often you wash out or run wide |
| 5 | Adjust gain only if needed | Move +1 at a time |
| 6 | Lock it in for a full week | Let muscle memory build |
The most valuable tip from the source is patience. Constantly changing everything keeps you from ever building muscle memory. Pick a setup, commit to it, and give your hands time to adapt.
Understanding Dead Zone
Dead zone matters more than most people expect. If it's too large, small steering corrections do nothing and the bike feels delayed. If it's too small, a worn or drifting stick can steer the bike on its own.
A community discussion about a different title, MX Bikes, offers a transferable idea. Community reports there suggest reducing the dead zone as low as you can comfortably handle, and turning down direct lean if steering feels too sensitive. Motocross The Game uses different menus, so don't expect identical options. The principle still applies: start with a small dead zone and raise it only if stick drift is a problem.
A quick test: set your controller down and see if the bike turns on its own in the menu or on the starting gate. If it does, raise the dead zone by a point or two.
Controller Bindings That Support Smooth Steering
Steering feel isn't only about the sliders. Where your thumbs sit changes how smooth your inputs are. This is the layout the reference rider uses on a PlayStation-style controller.
| Action | Binding |
|---|---|
| Throttle | R2 |
| Steering | Left stick |
| Rider lean | Right stick |
| Front brake | L2 |
| Rear brake | L3 (left stick click) |
| Sit/stand | L1 |
| Clutch | X |
| Gear down / up | Circle / Triangle (mapped to back paddles) |
Why Rear Brake on L3 Works
Putting the rear brake on a left stick click means you can brake-tap in the air without lifting your thumb from the steering stick. Rear brake taps are how motocross riders control bike pitch in the air, so this keeps your hands in position for landings.
Sit/Stand and Clutch Tips
The rider moved the clutch to X and sit/stand to L1 because of a wrist injury. Holding R3 down for a 15-minute moto was uncomfortable. If R3 works for you, a layout with clutch on L1 and sit/stand on R3 is perfectly fine.
One more suggestion from the source: use hold rather than toggle for sit and stand. The rider said the habit should pay off as Supercross content arrives, since you'll be standing and sitting constantly over rhythm sections.
If you don't have a controller with paddles, map gear shifts to buttons you can reach without leaving the sticks. Ergonomics beat copying.
Riding Aids and Braking: The Steam Trick
Steering and braking are linked. Corner entry depends on how well you slow the bike, and that depends on your aids. The reference rider runs only rear ABS, with front ABS, traction control, anti-stoppie, anti-wheelie and automatic gearbox all off.
| Riding Aid | Setting | Reason (player experience) |
|---|---|---|
| Front ABS | Off | Comfortable modulating the analog trigger |
| Rear ABS | On | Rear brake on L3 is on/off, so ABS prevents lockup |
| Traction control | Off | Full throttle control |
| Anti-stoppie | Off | Full control of front end |
| Anti-wheelie | Off | Full control of front end |
| Automatic gearbox | Off | Manual shifting |
Because L3 is a button, not a trigger, you can't squeeze it gradually. Without rear ABS, the rear wheel can lock, chatter or slide under braking. ABS smooths that out.
Combining Both Brakes With Steam Input
If you play on Steam, there's a clever tweak. Open the game in your Steam library, click the controller icon, choose Edit Layout, and go to Triggers. Under the left trigger, assign the soft pull command to left stick click (L3).
The result is that pulling L2 applies both brakes for corner entry, while L3 still works independently as a rear-only brake in the air. You get the best of both. You can read more about Steam's input tools on the Steam store and in its controller settings.
The rider also tested a clutch subcommand and didn't recommend it. Pulling the clutch every time you brake disengages the engine from the rear wheel, so you lose engine braking. It felt like the bike was free-rolling, and power returned inconsistently when the brake was released.
Camera, Display and Audio Settings That Support Control
Steering precision depends on seeing what's coming. These are the supporting settings used in the source.
| Category | Setting |
|---|---|
| Onboard 1 and 2 FOV | 120 |
| Display mode | Borderless windowed |
| Resolution | 2560 x 1440 |
| VSync | Off |
| Frame rate | Unlimited |
| Graphics | High preset |
| Master volume | 50 |
| Music | 30 |
| Environment, bike, other bikes | 50 each |
| Units | Imperial |
The FOV slider arrived in an update, and the rider says it made first-person riding feel much better. A wider view at 120 shows more of the track around the bike. If 120 feels distorted, try 115 or lower. Higher frame rates also help steering feel more responsive, so uncapping the frame rate is worth testing if your hardware can handle it.
Common Steering Mistakes and How to Fix Them
Even with good numbers, habits can sabotage your laps. Here are issues to watch for.
- Overcorrecting mid-corner. Big stick movements unsettle the bike. Make small, early inputs instead.
- Pushing too hard on short tracks. The source rider admits that on a short layout like Swedish Midsummer Carnage, the urge to attack every corner leads to tucked fronts and slides. Ride within yourself first, then add speed.
- Changing settings every session. You can't evaluate a setup you've ridden for ten minutes.
- Ignoring stick condition. A drifting stick can mimic a bad setting. Check your dead zone before blaming gain.
- Expecting settings to replace practice. Settings help, but track knowledge and bike control still decide lap times.
A good drill is to pick one corner and ride it 20 times, focusing only on smooth stick movement. Then compare your exit speed. It's boring, but it works.
FAQ
What are the best Motocross The Game steering settings for controller?
A well-tested starting point is steering gain +1, sensitivity -4, linearity 0 and dead zone 5. These come from a rider with about 70 hours who reached top-five and top-10 leaderboard times on the 250 class. Adjust one value at a time to suit your hands.
Should I raise steering gain for sharper turns?
Test it carefully. The source rider found gain values of +3 to +5 too sensitive, while 0 and -1 made turning difficult. If you want more bite, try +2 rather than jumping several points, and ride multiple laps before deciding.
Do Motocross The Game steering settings change with updates?
They can. The game just launched on November 16, and developers may adjust handling, menus or options. Recheck your steering and aid settings after major patches and be ready to retune.
Is rear ABS worth using?
For riders who bind the rear brake to a button like L3, community experience suggests yes. A button can't be squeezed gradually, so rear ABS reduces lockup and chatter. If you use a trigger for the rear brake, you may not need it.
Final Thoughts
Great Motocross The Game steering settings are about smoothness, not raw sensitivity. Start with gain +1, sensitivity -4, linearity 0 and dead zone 5, build a bindings layout that keeps your thumbs where they need to be, and consider the Steam soft pull trick if you're on PC. Then commit for a week before touching a slider again. Your lap times, and your landings, will thank you.
Related Guides
Motocross The Game Best Settings: Riding Aids, Controls, Camera and Braking Setup
Motocross The Game best settings after 70 hours: riding aids, steering values, controller bindings, a Steam braking trick, FOV and video options.
Motocross The Game Camera Settings: Best FOV, Views and Setup Tips
Dial in Motocross The Game camera settings with a 120 FOV first-person setup, camera switching tips, plus steering, brake and video options that help.
Motocross The Game Controller Settings: Best Setup for Control and Braking
Dial in your Motocross The Game controller settings: riding aids, steering values, button bindings, a Steam braking trick, and camera tips from a 70-hour setup.
Motocross The Game FOV Settings: Best Field of View and Camera Setup
Dial in your Motocross The Game FOV settings. Learn why 120 FOV works in first person, plus steering, braking and controller tips from player experience.